Where do I plug my reader in ? |
Contents Previous Next |
Introduction > Where do I plug my reader in ? The Temprecord program requires an available serial port or USB port on your computer to operate. The serial connector for this will be on the back of your computer, along with the connectors for the display and keyboard. It will be either a DB-9M (9-pin male) or a DB-25M (25-pin male) connector. A 25 pin-to-9 pin converter is supplied with the Reader Interface and you should use this if your computer is only fitted with a DB-25M connector.
If your reader has a USB connector, you need to plug it into a SUB port. These are normally located on the rear of desktop PCs, or on the side or rear of laptop/notebook PC's.
|
(C) 1992-2019 Temprecord International Ltd 20/04/2014 5:53:40 PM |
Temprecord Web Help |