The Auto Mode option to reuse the logger is set but no options have been set to save data, Continue?

Contents  Previous  Next

Error and Warning Messages > The Auto Mode option to reuse the logger is set 

You have attempted to start Auto Mode but Temprecord has found that you have the option to reuse the logger set, but you have no Auto Mode option set to read the logger and save the data.

 

If you continue, any data contained in the logger will be lost when the logger is reused.  You should make sure the data has been saved to disk at an earlier time before using auto mode with neither of the options to read the logger and save the data enabled.

 

If you do not want to be prompted for this question, and you understand the issues involved, make sure  the checkbox labeled "Don't ask me this again" is checked.

 

The state of this checkbox is only remembered for the current auto mode session.  If you exit auto mode, the prompt will be displayed the next time you start it.  It is not possible to permanently disable this warning.

See also:

Error and Warning Messages


(C) 1992-2019 Temprecord International Ltd
22/06/2011 3:33:58 AM
Temprecord Web Help