Unable to load named parameter set (reuse logger)

Contents Previous Next

Error and Warning Messages > Unable to load named parameter set (reuse logger)

Temprecord was unable to open the parameter set when reusing a logger.

If the logger user data is found to have been programmed with a Named Parameter Set, Temprecord will attempt to load the Named Parameter set from a file after reusing the logger. If the file cannot be found, an error message will be issued.

•Check the filename is valid

•Check that the file is not already held open by another network user.

The logger will be reused regardless of whether the named parameter set file is found. If you don't have access to the required Named Parameter Set file and don't require the existing logger parameters to be updated from a NPS, you can ignore the error message.