Error restoring logger parameters (xx)

Error and Warning Messages > Error restoring logger parameters (xx)

Temprecord was unable to update the parameter set in the logger to the set corresponding to the designated use of the logger.  The "(xx)" in the error message will be replaced with a more detailed description of the error that occurred.  This error may occur when applying a factory reset to a designated use logger.

Check the logger is correctly seated in the user interface.  

If the factory reset operation is being carried out on a computer other than the one the logger was programmed on, it may be that the Named Parameter Set file is not present.

See also:

Designated use loggers

Factory reset of loggers  

Error and Warning Messages