Setting up several loggers |
Contents Previous Next |
Program Menu > Setting up several loggers If you have several Temprecord loggers to set up in a single session, Temprecord makes it easy for you. The button marked 'Apply'' in the Program/Parameters form updates the information in the form to the logger, but leaves the form open.
To set up several loggers with the same or similar programmed data:
1.Place the first logger into the reader interface. 2.Select the Program/Parameters menu item. After a few seconds the Program/Parameters form will open with the parameters for that logger. 3.Make any changes you want to the user data, sample rate, etc. 4.Click on 'Apply'. A window will open while the Temprecord parameters are updated and after this is done you will be returned to the Program/Parameters form. 5.Remove the logger and insert the next one.
Repeat steps 3, 4 and 5 as many times as necessary to set up your loggers, then click on 'OK' to update the last logger and close the Program/Parameters form
See also: Setting up a default set of parameters
|
(C) 1992-2019 Temprecord International Ltd 20/04/2014 5:51:34 PM |
Temprecord Web Help |