Setting up a default set of parameters

Contents Previous Next

Program Menu > Setting up a default set of parameters

If you have a particular set of parameters that are frequently programmed into your loggers, you can create a 'default' set of parameters, which you can load into the Program/Parameters form simply by clicking on the 'Defaults' button.

To set up and use a set of default parameters:

•Select the Options/Defaults menu item. This will open the default options form, which looks very similar to the Program/Parameters form, except that there is no 'password' field.'

•Enter the parameters. You might for example have a particular set of user data, which remains the same for all loggers apart from one line, being the destination of produce being shipped. You would leave that line blank here.

•Click on OK.

To use the default set of parameters:

•Place a logger into the reader interface.

•Select the Program/Parameters menu item. After a few seconds the Program/Parameters form will open with the parameters for that logger.

•Click on the 'Defaults' button. This will load the user data with the defaults you programmed previously.

•Make any changes you want to the user data, sample rate, etc. In the example mentioned above, you would key the destination into the line left blank.

•Click on 'Apply' or 'OK'.

•Remove the logger.