Error and Warning Messages > The "Start at Time and Date" parameter has been disabled
This logger has a Named Parameter Set (NPS) specified in the user data and a NPS of the same name is present on the disk. When this occurs the parameter settings are read from the NPS on disk into the controls in the parameters dialog.
|
This means that the settings in the dialog are not necessarily the same as the settings in the logger. |
On this occasion the NPS on disk has the Start at Time and Date feature enabled, but as a safety precaution this setting has been disabled in the dialog controls. The reason for this is that the act of saving the parameters to a LCD logger will start the logger and it will begin counting down to the Start at Time and Date time. The parameters in the logger cannot be accessed once this has been done.
|
If you require the Start at Time and Date feature you will need to select it again, and ensure that the time and date is in the future, and a sensible date. |
See also
(C) 1992-2019 Temprecord International Ltd